Tricity Bendix TBG700X Bedienungsanleitung PDF herunterladen (Seite 8)

Operation



Hob burners control knobs

The symbols on the knobs mean that :

 there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting

a pan on the pan support.

To light a burner:

 push in the relevant control knob and turn it

anticlockwise to maximum position ( ), to

ignite the burner.

 Then adjust the flame as required.

 To put the flame out, turn the knob to the symbol

.

If the burner does not ignite, turn the control knob

to zero, and try again.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. - lett. A) and the"crown" (Fig. - lett. B) are in the correct

position.

When switching on the mains, after installation or a power cut, it is quite normal for

the spark generator to be activated automatically.

In the absence of electricity, ignition can occur without the electrical device; in

this case, approach the burner with a flame, push the relevant knob down and turn

it anti-clockwise until it reaches the “maximum” position.

Do not keep the control knob pressed for more than 15 seconds. If the burner

does not light even after 15 seconds, release the control knob, turn it the “off”

position and wait for at least one minute before trying to light the burner again.

If the burner accidentally goes out, turn the control knob to the “off” position

and wait for at least 1 minute before trying to light the burner again.

If the control knobs become difficult to turn, please contact your local Service

Force Centre.

A - Burner cap

B - Burner crown

C - Ignition electrode

Triple crown burner

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Keine Kommentare

Tricity Bendix TBG700X Bedienungsanleitung Seite 8